LED eFoil and Foil Board Light Kit by ActionGlow, Fits LIFT5, LIFTX and Surf Foil Boards
Fly at sunset and keep going. We set this kit up for eFoil and foil boards, using the ActionGlow AG2 surfboard system with two long LED strips that run the length of the rails. On a LIFT5, LIFTX or a Lift surf foil board it lights the whole outline, so the people on the beach, the boat behind you and your friends on the water can all see where you are. And it looks really good up on the foil at dusk.
The strips are about 6 ft each, so they cover the full rail on most eFoil and prone boards. If your board is shorter, trim the ends and seal them with the new end caps that come in the box.
Where to mount it
- Rails: the classic look, the whole outline glows
- Deck edge: easy to see from above and simple to reach the control box
- Bottom of the board: lights the water under you. Route the cables and tuck the battery boxes behind a tail pad or the traction pad on the deck side
Keep the strips and boxes clear of the battery hatch, the mast mount and anything you need to open or bolt on. Not sure where it should go on your board? Send us a photo and we will help you lay it out.
What you get
- 7 colors and 3 brightness levels, run from a simple two button control box
- IP68 rated, fully waterproof LED strips and power supplies
- Black PCB strips and a compact battery box that stay low profile when the lights are off
- Sticks on with 3M VHB adhesive, so no drilling and no screws in your gear
- Install takes about 5 to 10 minutes and the cleaning packet and adhesive promoter are in the box
- ActionGlow rates the LEDs as visible from over half a mile, with a 180 degree viewing angle
- Whole system weighs under 14 oz
In the box: 2 premium LED strips, about 2 m (6 ft) each, with replacement end caps; 2 waterproof power supplies; 2 cleaning solution packets; 2 adhesive promoters.
Install tip: clean the spot with the alcohol pad, wipe on the adhesive promoter, stick the strip and press it down well. Let it sit for 48 hours before it goes in the water.
Power: runs on two 9V batteries (not included). Grab the ActionGlow USB-C rechargeable 9V 2 pack if you want to skip the gas station run. ActionGlow quotes up to 6 hours at medium brightness on a 1 meter system with those, and runtime changes with strip length, brightness and temperature.
Warranty: 1 year ActionGlow manufacturer warranty against defects.
LIFT, LIFT5 and LIFTX are Lift Foils names, used here only to show fit. This is an ActionGlow product and is not made or endorsed by Lift Foils.